窗户是在装修业中特别重要的部分，不仅能起到抗风挡雨的作用，还能对房屋起到隔音保温效果。所以，在进行窗户的装修时，越来越多的人会使用双层中空玻璃窗，可是双层玻璃窗起雾怎么办呢？
Windows are particularly important in the decoration industry. They can not only resist wind and rain, but also have sound insulation and heat preservation effect on the house. Therefore, in the decoration of windows, more and more people will use double-layer insulating glass windows, but what about the fog of double-layer glass windows?
中空玻璃起雾原因
Causes of insulating glass fogging
1.中空玻璃窗在安装时，其的施工工艺不佳，在使用一定的时间后，其中的密封胶发生开裂的现象，导致水汽进入中空玻璃的夹层中，随着温度的升高，水汽蒸发，在与玻璃面接触时，变为小型的水珠，从而导致双层玻璃起雾的现象。
1. During the installation of hollow glass window, its construction process is poor. After a certain time of use, the sealant cracks, resulting in the water vapor entering the interlayer of hollow glass. With the increase of temperature, the water vapor evaporates and becomes small water droplets when in contact with the glass surface, resulting in the fogging of double-layer glass.
2.双层中空玻璃在安装时，由于里面的水槽未安装好，导致他的水面高于型材，从而导致水流流入双层玻璃的夹层中。在阳光的照射下，水蒸气形成雾气，从而造成双层玻璃的起雾现象。

2. During the installation of double-layer insulating glass, because the water tank inside is not installed properly, the water surface is higher than the profile, resulting in water flowing into the interlayer of double-layer glass. Under the sunlight, water vapor forms fog, resulting in the fogging of double-layer glass.

3.中空玻璃在安装时，如果隔条在进行粘贴时，与玻璃的边缘处没有留一定的缝隙，则其在于雨水接触时，会将雨水吸附到双层玻璃上，从而导致双层玻璃发生起雾的现象。若室内的温度与室外的温度相差过大，且其室内的空气湿度过大，就会发生双层玻璃起雾的现象。
3. During the installation of insulating glass, if there is no gap between the spacer strip and the edge of the glass, the rain will be adsorbed on the double-layer glass when it is in contact with the rain, resulting in fogging of the double-layer glass. If the difference between indoor temperature and outdoor temperature is too large, and the indoor air humidity is too large, the phenomenon of double-layer glass fogging will occur.
中空玻璃起雾的解决方式
Solutions to fogging of insulating glass
1.若是因密封胶未封严密而造成的中空玻璃起雾的现象，则可将中空玻璃上的密封胶用工具拆除，并重新将玻璃窗清洗干净，待其干燥后，再进行玻璃密封胶的涂刷工艺。
1. If the insulating glass is fogged because the sealant is not sealed tightly, the sealant on the insulating glass can be removed with tools, and the glass window can be cleaned again. After it is dry, the brushing process of glass sealant can be carried out.
2.若双层中空玻璃窗的水槽位置未安装好，则要将中空玻璃窗拆除掉，并进行重新安装。
2. If the sink position of the double-layer insulating glass window is not installed properly, the insulating glass window shall be removed and reinstalled.
3.若双层中空玻璃中隔条已安装好，则可在双层玻璃窗上添加玻璃垫片。另外还可以将其上原有的中隔条除去，在重新安装上隔条，要注意隔条的粘贴位置要与玻璃窗的边缘部分保持一定的间距，一般是2mm为合适。且在安装玻璃窗时，要注意不要在隔条上沾上水，以免影响其的安装质量。若是温差相差过大而引起的起雾现象，则可将窗户打开一会，让室内外的温差的差距变小，待其的上雾气散去为止。
3. If the middle partition strip of double-layer insulating glass has been installed, glass gasket can be added to the double-layer glass window. In addition, the original middle spacer can be removed. When reinstalling the upper spacer, it should be noted that the pasting position of the spacer should keep a certain distance from the edge of the glass window, generally 2mm. When installing the glass window, pay attention not to dip water on the spacer, so as not to affect its installation quality. If the temperature difference is too large to cause fog, you can open the window for a while to reduce the difference between indoor and outdoor temperature difference until the upper fog dissipates.