立式玻璃钻铣机为PLC自动控制，操作时只需将玻璃放在传送带上，输入钻孔位置数据，启动按钮，自动定位后钻削所有孔位，完成工作后自动停机，钻孔效率高，孔位准确，适用于建筑玻璃与家具玻璃的加工；彩色人机触摸屏操作自动化控制，介面清晰、操作简便参数设定后一次加工完成；PLC程序控制，具有自动检测、诊断功能，电路稳定性高、对作业环境适用性大，并可进行远程维护、升级。

The vertical glass drilling and milling machine is automatically controlled by PLC. During operation, just put the glass on the conveyor belt, input the drilling position data, start the button, drill all hole positions after automatic positioning, and stop automatically after completing the work. The drilling efficiency is high and the hole position is accurate. It is suitable for the processing of architectural glass and household glass; Color man-machine touch screen operation automation control, clear interface and simple operation, and one-time processing is completed after parameter setting; PLC program control, with automatic detection and diagnosis functions, high circuit stability, great applicability to the working environment, and remote maintenance and upgrading.

使用方法：
usage method:
1．钻玻璃时，立式玻璃钻孔机下钻头易挤碎玻璃，所以钻薄玻璃时，压力时，压力必须调得很低，可在0.18～03MPa范围内变化，钻厚玻璃时，压力可以上升到0.46MPa左右。
1. When drilling glass, the drill bit under the vertical glass drilling machine is easy to crush glass. Therefore, when drilling thin glass, the pressure must be adjusted very low and can vary within the range of 0.18 ~ 03mpa. When drilling thick glass, the pressure can rise to about 0.46mpa.
2．每班工作开始前，应先给立式玻璃钻孔机各注油部位注入润滑油，并检查皮带松紧程度，上、下钻轴运转有无异常，钻头是否磨损，待一切正常后方可开始工作。
2. Before the start of each shift, inject lubricating oil into each oil filling part of the vertical glass drilling machine, check the tightness of the belt, whether the operation of the upper and lower drilling shafts is abnormal, and whether the drill bit is worn. The work can be started only after everything is normal.
3．接料抽屉中的芯料应及时进行清理，否则料芯堆积太多会卡死接料器。特别是钻削直径大于100mmj的大孔时，每钻几个孔就应清理一次。
3. The core material in the receiving drawer shall be cleaned in time, otherwise too many cores will jam the receiver. In particular, when drilling large holes with a diameter greater than 100mmj, clean them every few holes.
4．清理立式玻璃钻孔机芯料时应使接料器处于接料位置，以便接料抽屉能顺利抽出，所以清理玻璃钻孔机芯料时要上钻头启动旋转，此时接料器便处于接料位置，可以方便地清理料芯。
4. When cleaning the core material of the vertical glass drilling machine, the feeder should be in the receiving position so that the receiving drawer can be pulled out smoothly. Therefore, when cleaning the core material of the glass drilling machine, the drill bit should be started to rotate. At this time, the feeder will be in the receiving position, which can easily clean the core.